Cummins X12 CM2350 X119B (2018 & Newer) Fault Code: 4769 PID: SPN: 1761 FMI: 10 Aftertreatment 1 Diesel Exhaust Fluid Tank Level Sensor- Abnormal Rate Of Change

whatsapp +51955515985
support@ecuforcetruck.com
24/7 Customer Support

Shop

Account

Cart$0.00

Subtotal: $0.00

No products in the cart.

Circuit Description
The aftertreatment diesel exhaust fluid tank level sensor is used to monitor the aftertreatment diesel exhaust fluid level inside the aftertreatment diesel exhaust fluid tank.

Component Location
The aftertreatment diesel exhaust fluid tank level sensor is located in the aftertreatment diesel exhaust fluid tank. Location of the tank and level sensor is OEM dependent. Refer to the OEM service manual.

Conditions for Running the Diagnostics
The diagnostic runs continuously when the following conditions are met:

Keyswitch is in the ON position or when the engine is running.
Ambient temperature is above -20°C [-4°F].
Vehicle altitude change is less than 305 m [1000 ft] in 1 hour.
Conditions for Setting the Fault Codes
The Engine Control Module (ECM) detected the aftertreatment diesel exhaust fluid tank level sensor reading was invalid for an extended period of time.

Action Taken When the Fault Code is Active
The ECM illuminates the amber CHECK ENGINE lamp and/or the Malfunction Indicator Lamp (MIL) immediately when the diagnostic runs and fails.
Engine torque will be reduced if the engine is operated for an extended period of time with this fault active.
Conditions for Clearing the Fault Code
To validate the repair, perform a key cycle, start the engine and let it idle for 1 minute.
The fault code status displayed by INSITE™ electronic service tool will change to INACTIVE immediately after the diagnostic runs and passes.
The ECM will turn off the amber CHECK ENGINE lamp immediately after the diagnostic runs and passes.
For On-Board Diagnostics (OBD) engines, the ECM will extinguish the Malfunction Indicator Lamp (MIL) after three consecutive trips where the diagnostic runs and passes.
The Reset All Faults command in INSITE™ electronic service tool can be used to clear active and inactive faults, as well as extinguish the MIL for OBD applications.

Shop Talk
Possible causes of this fault code include:

A malfunctioning aftertreatment diesel exhaust fluid tank level sensor
Tampering of the aftertreatment diesel exhaust fluid tank level sensor

Possible Cause:
1) Aftertreatment DEF tank level/temperature/quality sensor failure
2) ECM calibration

Categories Cumminz, DTC TRUCKS, Tags , 1, 10, 1761, 2018, 4769, Abnormal, Aftertreatment, Change, CM2350, Code, Cummins, Diesel, Exhaust, Fault, Fluid, FMI, Level, Newer, of, PID, Rate, Sensor-, SPN, Tank, X119B, X12

FacebookTwitterYoutube

Wiring Diagrams

Component Locators

Navkal 2018 offline version remove DPF MAXXFORCE 13 EPA 10
Navistar$80.00
Rated 0 out of 5
DOWNLOAD CNH EST 9.8 ENGINEERING
CNH$115.00
Rated 0 out of 5
MAN MANTIS v666 EPC [09.2021] Spare Parts Catalog
MAN$80.00
Rated 0 out of 5
Diagnostic Software PSI Powerlink 2.3.1
PSI Powerlink$94.00
Rated 0 out of 5
JPRO 2022 v3 ( 1 PC )
JPRO$94.00
Rated 0 out of 5

Cat Factory Password Generator 1.0 2019 WINDOWS 10
CAT$55.00
Rated 0 out of 5
NAVISTAR ENGINE CYLINDER PERFORMANCE ANALYZER V7.8.8.1
Navistar$52.00
Rated 0 out of 5
download JPRO 2023 1.2 off-highway – on-highway
JPRO$96.00
Rated 0 out of 5
JPRO Diagnostic Software Download 2024
JPRO$100.00
Rated 0 out of 5
Meritor WABCO Toolbox 12.12 Software
Trucks software$40.00
Rated 0 out of 5
CATERPILLAR FLASH FILE 2021 74 GB ( Collection 2021 ) sofware trucks
CAT$55.00
Rated 0 out of 5
Volvo PROSIS Offline 2019 Parts Catalog Installation Service
Trucks software$45.00
Rated 0 out of 5
See Also
Fault Codes Explained – DEF Sensor Simulator
Navkal 2018 offline version remove DPF MAXXFORCE 13 EPA 10
Navistar$80.00
Rated 0 out of 5
John Deere$200.00
Rated 0 out of 5
PACCAR Electronic Service Analyst 5.4.3.0 SW files 27.03.2021 software trucks
PACCAR$60.00
Rated 0 out of 5
CAT ET 2021A (Caterpillar Electronic Technician) + Factory Password (1 PC )
CAT$65.00
Rated 0 out of 5
Detroit Diagnostic Link (DDDL 8.09) Engineering level 10
Detroit$40.00
Rated 0 out of 5
NEXIQ eTechnician 2.1.7657.26963 + Patch 2020
Allison$60.00
Rated 0 out of 5
JPRO 2023 v3 diagnostic software latest version
JPRO$100.00
Rated 0 out of 5
JCB ServiceMaster 4 v21.4.2 [05.2021] Diagnostic Software
JCB$85.00
Rated 0 out of 5

Cummins X12 CM2350 X119B (2018 & Newer) Fault Code: 4769 PID: SPN: 1761 FMI: 10 Aftertreatment 1 Diesel Exhaust Fluid Tank Level Sensor- Abnormal Rate Of Change - EcuForce Truck (2024)

Related

Related products